show off your beadlock wheels

Whiten · Dec 30, 2012

393771_105318982920399_100003268925621_21394_428027674_n1.jpg

Nuts · Dec 30, 2012

No bling here, just 36 bolts to keep the bead on! These are 16.5s and I made an inner safety lip too. Being cheap is hard work!

Rockrunner86 · Jan 12, 2013

Here is one we recently completed for a customer of ours. www.totalmetalinnovations.com

haddix505 · Jan 12, 2013

Re: Re: show off your beadlock wheels

Sent from my DROID RAZR using Tapatalk 2

fireman108 · Jan 12, 2013

84turbotoy · Jan 13, 2013

Rockrunner86 said:
Here is one we recently completed for a customer of ours. www.totalmetalinnovations.com

muddinmetal · Jan 13, 2013

TURNEROFFROAD said:
Old trusty H1's

Very nice sir :dblthumb:

85buggy · Jan 14, 2013

How bout the blondes bead locks ?

Rjhoward32006 · Jan 14, 2013

Nothing special but they work

53045E48-3F98-4ABF-A8ED-4C684069AD29-475-00000048CDA14188.jpg

constant pressure · Jan 15, 2013

FIREMAN108 where did your beadlocks come from I really like them

ridered3 · Jan 15, 2013

bryanb123 said:
not sure if it helps coning, or even what that is. I did it to be different and to decrease the plate deflection by offsetting the bolt pattern.

Newbie beadlock question, how would one go about setting up a set to avoid plate deflection.coning like this?

Worros · Jan 15, 2013

ridered3 said:
Newbie beadlock question, how would one go about setting up a set to avoid plate deflection.coning like this?

I saw some weld on beadlocks on ebay, cant remember the company, but they had a small 3/8" or 7/16" ring that would fit on the inner ring on the inside of the 32 bolts that would prevent it from coning

Rockrunner86 · Jan 18, 2013

constant pressure said:
FIREMAN108 where did your beadlocks come from I really like them

We can make you as set like that.

www.totalmetalinnovations.com

constant pressure · Jan 22, 2013

No phone #?

ridered3 · Jan 22, 2013

ridered3 said:
Newbie beadlock question, how would one go about setting up a set to avoid plate deflection/coning?

Any opinions on how to do this?

5onrocks · Jan 22, 2013

My old faithfuls with some new paint and hardware.... Only thing i will change to is 17" Aluminum to run some stickies.

The Buggy is getting a face lift before KOH

jkh533 · Jan 22, 2013

ridered3 said:
Any opinions on how to do this?

http://www.diybeadlocks.com/ProductDetails.asp?ProductCode=Anti-Cone+Rings

or something similar

bamatoy · Jan 22, 2013

On pirate vendor section, there was a company that offered some rings with what looked like .250 standoffs to prevent coning. Can't recall the company but should be easy to find.