Anyone running flanges on a non CV 1410 shaft? What set up are you running? In the middle of 4 linking and I have flanges on both ends. I'm a little concerned about binding with standard flanges at full droop. My I know my rear drive shaft will be approx 39.25 flange to flange. Thinking about re-drilling my flanges and making a pilot spacer to run this pictured spicer 3-2-1159. I want to keep parts that are readily available from multiple vendors.
I have found another yoke from Powertrain industries that's looks like it will work and has a matching 4.25 bolt pattern that my flanges have. Part# 4102-256 says it's an AAM flange picture shows 40067202 stamped in it. Googling either part number I cannot find another source for this flange nor do I know what application it was for. If anyone can help I'm all ears.
I have found another yoke from Powertrain industries that's looks like it will work and has a matching 4.25 bolt pattern that my flanges have. Part# 4102-256 says it's an AAM flange picture shows 40067202 stamped in it. Googling either part number I cannot find another source for this flange nor do I know what application it was for. If anyone can help I'm all ears.
