smbroady82, Man I plan to use them on the main supports that tie in over the hood.

Reason: Basically I cannot get in there and weld it solid. Also by using the bungs I will be able to disconnect and remove the top portion (for whatever reason I may need to). I assume those bungs are pretty stout....I rolled a couple rzr's in my time and the bung support held up nicely.. Do you have any concerns or suggestions you could share? Am I overlooking something?

The picture below shows main front support. I can get in all places and weld (although its going to be tight). Over the cab is another story thus I need some bungs..

*PS: If any of you Yota guys need any drawings...I have several I have done over the past few years (complete detailed drawings of bumper supports, cages, etc.) just let me know.