97 cummins fuel plate and governor springs?

War-Jeeper · Nov 13, 2009

Who here has installed them before? Id rather have somebody help me whos done it before rather than me just diving into it blind.

Not Jobless · Nov 13, 2009

Try the Bomber board

zukkev · Nov 13, 2009

War-Jeeper said:
Who here has installed them before? Id rather have somebody help me whos done it before rather than me just diving into it blind.

:hi: It's not hard Sam!:awesomework: Which springs did you get??? 3K???

www.thedieselgarage.com has a good step-by-step for this!!! Check it out!

War-Jeeper · Nov 13, 2009

I got the 3k springs and a #10 plate

and i know it isnt super hard i just get indidmated i guess

War-Jeeper · Nov 13, 2009

zukkev said:
:hi: It's not hard Sam!:awesomework: Which springs did you get??? 3K???

www.thedieselgarage.com has a good step-by-step for this!!! Check it out!

Where on there did you find the info Kevin?

zukkev · Nov 13, 2009

Did you register on there??? I'll go check & see if I can find it...Look for 'strokinit' being online!:redneck: lurkin' in the 12V section!!!:haha:

War-Jeeper · Nov 13, 2009

zukkev said:
Did you register on there??? I'll go check & see if I can find it...Look for 'strokinit' being online!:redneck: lurkin' in the 12V section!!!:haha:

No i havent yet

zukkev · Nov 13, 2009

I can't seem to find the exact thread that illustrates the procedure

...but it is there!!! :awesomework: There are a couple stickies in the 12V section that do explain it though!!! (Sorry it took so long to post back, I got sucked into the forum reading about it all!!!:haha

...