Anyone running Profender coilovers and/or bumps lately?

the_white_shadow · Jun 11, 2015

Anyone buy from Profender lately? Haven't seen them much on on of the forums and all of the reviews are older. I have been running their 2.0 remote resi coilovers for a couple years without issues. Now that I'm linking the front I want to go back to them again and order some for the front. Also ordering 4 of their 3" bumps.

Thanks in advance - Alex

b.boyd · Jun 11, 2015

I can't say anything on their coil overs other than they showed my nice looking bypass so KS they had a the trade show last year....as for their bumpstops, I have been running them for a few years.. no problems and good quality on inside. They pretty much the same on the inside as aFox bumpstop...I beat the hell out my bumpstops including jumping my buggy without any issues. I think you will be happy with them. If you have any problems look up Dean Benner . He runs the US side of profender.

the_white_shadow · Jun 12, 2015

Thanks for the post. I sent Dean an email yesterday just to make sure they are still manning the emails, and they are. I have been running their c/o's in the rear and like them a lot. Just wanted to make sure they were still around and producing quality parts before I ordered new ones.

poolman · Jun 12, 2015

I run them with King cos no issues, ride well to me

zjtrey · Jun 13, 2015

i'm running pro fender coil overs on my transaxle build, the quality seems nice on shocks, no complaints so far

natedawgxj · Jun 17, 2015

I run profenders. I would go with Fox and be done with it just my .02

Neal3000 · Jun 17, 2015

If your building your rig for the longterm then i would be worried about them possibly going under someday and not being able to get parts

zjtrey · Jun 17, 2015

natedawgxj said:
I run profenders. I would go with Fox and be done with it just my .02

I would do the same if i were making the decision again….

natedawgxj · Jun 17, 2015

Neal3000 said:
If your building your rig for the longterm then i would be worried about them possibly going under someday and not being able to get parts

X2

SB406 · Jun 18, 2015

Profender is still around. Dean is still doing it, and he was at the UOR Expo with a Profender booth a couple weeks ago. I have the 2.0 threaded bump stops on my new truck.