Do any of you guys know of someone local who is familiar with machining my flat top knuckle for high steer? Im sure if I gave any machinest the dimensions they could do it but Id rather have someone whos done a few before do it so they have that confidence. I know theres tons of places you can send them out to but Id rather keep it local. Also any YJ guys out there that are SOA shackle forward with rubicon 1.5" soa springs running their tie rod over the spring? If so howd it work out for you?
-
Help Support Hardline Crawlers :
chevy 3/4 ton dana 44 steering
- Thread starter rchrd989
- Start date
My setup to a T. I'm using chevy 1-ton TRE's and 1.5" .25 wall DOM, MAD4WD hi-steer arms, on a waggy 44, shackles up front, 1.5" RE SOA springs. No issues at all, it steers great and the drag link is nice and flat, nothing touches.
As far as the local machining of the knuckle... can't help ya there, I had mine done in Wenatchee at driveline service of wenatchee and it turned out ok (not "perfect" but it works).
Toyotanut
Well-Known Member
I think Bunk here on the board could do it for you. I'm not 100% sure though. Otherwise call S&N
