D60 shafts and joints

nick c · Feb 3, 2008

Im looking to order a set of axle shafts and u-joints for my Dodge 60 front. I'd love to run bobby's CV shafts but can't afford them.

Who's running what, are you happy? Any broken parts?

So far i've been looking at Alloy and Yukon shafts 35 spline inners and outters. Then there are CTMs, Ox-joints, and yukons for the joints. They are all fairly close in price.

Any advice?

Cascade_Crawler · Feb 3, 2008

I have yukons and stock spicer joints. hasnt left the garage yet but yukon has a good warranty :haha:

Bunk1 · Feb 3, 2008

I got yukon inners/outers and bobby joints. The long side inner splines are just starting to twist after a season, Thats about the only issue so far. Lubing the joints sucks ass as well, But knowing their done is worth the time.

One other thing, You will most likely have to grind down the ears on yukon shafts so they will fit thru the knuckle hole..

Roccrawler · Feb 3, 2008

yukon , inner, outer, and yukon superjoints... full warrenty on all the part which is nice to have all from the same place.

nick c · Feb 3, 2008

Roccrawler said:
yukon , inner, outer, and yukon superjoints... full warrenty on all the part which is nice to have all from the same place.

Yeah, for me the warranty is big. Ill have to read up on the warranties, is it a no question asked deal? if my u-joint fails and takes out my shaft both are going to be replaced, thats what I'm hoping to get out of a warranty.

If I buy my shafts/joints through a PBB vendor, will I have to go through him to get them warrantied or can I go straight to Yukon? Anyone know?

jeepmauler · Feb 3, 2008

Roccrawler said:
yukon , inner, outer, and yukon superjoints... full warrenty on all the part which is nice to have all from the same place.

X2.............

PORTER · Feb 3, 2008

I bought Yukons(60) from randys. Finally broke one after 3 years of wheelin and they replaced it free of charge. Everything breaks, but its nice to be taken care of when it happens. Not even running a performance U-Joint yet. Some day.:redneck:

sarg · Feb 3, 2008

I had yukon axels with bobbys joints and they worked good, the splines on the yukons are getto looking. If I did it again on a budget I would get Alloy usa and bobbys joints, but this time Im running spidertrax axles and bobbys joints

Roccrawler · Feb 3, 2008

PORTER said:
I bought Yukons(60) from randys. Finally broke one after 3 years of wheelin and they replaced it free of charge. Everything breaks, but its nice to be taken care of when it happens. Not even running a performance U-Joint yet. Some day.:redneck:

I twisted a rear yukon shaft, didnt break, but replaced with no questions.. gotta love that