• Help Support Hardline Crawlers :

Reply to thread

Hmmm, not sure I buy that. I have the pinion pointed direction at the t-case output just like I have in my 4Runner.


Crash says, "A shot of the front driveline installed. I think I'll take the boot off. It only has about 1/2 the travel of the driveline, which is a 10" travel. The upper joints are 1 ton CV joints and lowers are the 1350s. Check out the nice angle at the pinion - almost dead on straight."


Not as good a shot as the front but the rear is again sitting at 0 degree pinion angle.


I'll be using similar drivelines on this rig.


Back
Top