need help with a 60

roll over dave · Jul 30, 2008

i scored a dana 60 front by doin a few hours of work, its a dually need how to make it single wheel width do i have two get anytin machinced thanks foe the help

Opossum · Jul 30, 2008

I could be wrong but I think all you have to do is swap the DW for a SW hub.

Beyer · Jul 30, 2008

I believe there is a way to machine them as well, but I would have to confirm that. ???

blacksheep10 · Jul 30, 2008

swap hubs or machine yours off in a lathe. its easier to just swap hubs.....if you can find the hubs. if you have a lathe and some time, turn them bitches down. :woody:

I've done both.

roll over dave · Jul 30, 2008

thanks im just goin to put new ones on it buyin 35 outers any way

74_Chevota · Jul 31, 2008

Well going 35 spline doesnt have much to do with it. They are talking not just about the locking hub, but the whole bearing assembly. I swapped hubs on my DRW 60 from a SRW but they are pretty hard to find for cheap. Doug and Extreme Axle sells them new with bearings and brakes for a decent price. Then when you get time, machine them down and sell the DRW to someone else like I did. Easy enough and tons of threads on pirate 4x4.