• Help Support Hardline Crawlers :

Recommendations for Custom Sheetmetal Work

ZedMikey

Well-Known Member
Joined
Oct 9, 2006
Messages
1,469
Reaction score
0
Location
Auburn, WA
I want the front fenders on my truck modded to open up the wheel well, and rather than have me butcher them with a sawzall, I'm thinking about having it done professionally. I don't have the time, tools, or ability to do this and make it look good in the end. Especially the inner fender mods necessary.

Basically, I want this done to my Dodge, too. :D 38.5" tires without a lift... I'm all about that. :redneck: Who's good and reasonably priced?

P1010254.jpg
 
Hi All:

Consider TorFab in Lynnwood:

http://www.torfab.com/

He did the bob-job on that FZJ80 Land Cruiser wagon featured on the site, so he knows how to work with sheet metal.

Good luck!

Alan


I want the front fenders on my truck modded to open up the wheel well, and rather than have me butcher them with a sawzall, I'm thinking about having it done professionally. I don't have the time, tools, or ability to do this and make it look good in the end. Especially the inner fender mods necessary.

Basically, I want this done to my Dodge, too. :D 38.5" tires without a lift... I'm all about that. :redneck: Who's good and reasonably priced?

P1010254.jpg
 
Thanks for the tip, Alan.

Nobody else has any suggestions?

I can hook you up with the material and know how to do some. I dont want to do it:fawkdancesmiley:. Someone like Brad (chop shop) or Corey (crazy daze) Might be able to take care of something like that. Here is what i did. just a mix of 14 guage sent through a roller/16 guage cut out with a jigsaw.

If you wanna come take a look, or want some rings rolled, pm me. I know some people. :redneck:

http://www.pirate4x4.com/forum/showthread.php?t=813244&page=9
 
Thanks for the tips, Marc, but I don't have the time or space to do it myself. No garage, no welder, I'm actually working full-time again, etc. Though... I could always pull it into the high bay here at work. I did threaten to do that. :D

Nobody else has any recommendations for me?
 
Someone like Brad (chop shop) Might be able to take care of something like that.

Thanks Marc.:awesomework:

I can do it for ya if interested. I have done alot of patch panels and sheetmetal work on all kinds of rigs. From 64 impalas to putting truck roofs on 4runners, ive done a bit of everthing.

That dodge has nice tin too. good to weld on. PM me if interested.:beer:
 
Back
Top