sheet metal???

Boonie Buster · Jan 19, 2007

anyone know of a good place(or have some) thinner sheet metal for use as a floorin in the cab of a truck??? i think i'm gonna have to do some serious cutting oin my floor to fit recent acquisitions, and i think have decide for simplicity of future seat mounts that i'm going to cut out the floor and insert some of this stuff. anything i should be aware of or suggestions for doing this? thanks.

Toyotanut · Jan 19, 2007

go to Jerry's Iron Works right there as you get into Duvall. That's were I went for mine

Boonie Buster · Jan 20, 2007

Toyotanut said:
go to Jerry's Iron Works right there as you get into Duvall. That's were I went for mine

just the guy i was looking for with an answer:; did you have to use any cross bracing on yours, IIRC you didnt have to

ToyZuki · Jan 20, 2007

Real estate signs are a good source for thin steel. And if you need to buy a house just lift up the carpet to get the #

Toyotanut · Jan 20, 2007

No I didn't have to use any cross bracing but it did bow a little bit. I would think you wouldn't need it since you are only doing a single cab span where as I did an extra cab span. However if you have the room to run a support piece from one side to the other I'd do it. That way you wouldn't have to worry about the floor bowing. Any who....enough ramblings for now