well that problem fixed and now new or other issues that were not as important but are issues still.
this is freaking wierd, and i have to say i hate wires......:
so MAP ref sig is now 5V as is TPS and Temp Sender, however i am still getting incorrect voltage out on the signal wire. the sensers are NOT BAD.
so let take them one at a time.
MAP, 5V in, .1V out only raises to 2.5V max? should be 1V to 4.5V
TPS, 5V in. 0.25V out ad idle and 2.5V at WOT? should be 1.2V 4.5V
if i take both sensers out and place them in a known good runner they perform exactly as per spec. put them back in my rig and voltage is off.
put the known good sensers in my rig and the voltage is off.
now get this: if i un plug the TPS and plug in an extra MAP reading atmosphere it runs fine........
