new tube buggy from across the water

tomcat404 · Feb 11, 2014

Sorry for the delay on the build i have been moving units to a place where i have more space so i can actually get some work done!

So....progress so far...... I have a pto on my atlas box for my new twin drum mechanical winch!,!,,,, I bet you`ve not seen one of those before? Ill post pictures when i get a minute,

Also cut all the original flat steel shocks mounts off as they were ****.

Have a new shock mounts to fit all round, new battery boxes and a new atl fuel cell!

tomcat404 · Sep 22, 2014

its been 6 months since i last updated this thread? thanks to everybody and the words of advice.!

so.. i bought another buggy to go any play with while i slowly finish this one and have competed a few times getting 9th and 12th out of about 30+ entrants on most events.

Progress with this buggy had really moved on and i have been making steering arms for the spidertrax knuckles and milnershave made me some sweeeeeet half shafts for the custom portals and the ctm joints ! pictures to follow.

If all goes well i should have the truck fully dry built by the end of november ready for the strip down over christmas and finally paint and getting the bling going..

so pictures of the shafts to follow !!!

tomcat404 · Sep 22, 2014

a few off the half shafts... made of 300m heat treated and shot peened. 35 spline to go from rd 99 air locker to the CTM joint them stub shaft to the portal box