Throwing in the towel - my MarsFab buggy build

untchabl · Sep 24, 2021

Chris has been making progress but I have slacked on posting updates since getting back from vacation.

Brakes and fuel system done. Fan shroud made and radiator modified. Intake done. Orbital mounted and working on steering plumbing now.

untchabl · Sep 24, 2021

More pics.

untchabl · Oct 30, 2021

Chris has been making more progress on the buggy. It's fully plumbed, he double sheared the steering knuckles, added a storage area in the rear and has started knocking out the interior.

untchabl · Oct 30, 2021

Interior work so far

untchabl · Oct 30, 2021

Couple weeks ago he stripped it down and fully welded out the chassis, added the boat sides and mounted all the skid plates. The bottom skid didn't have the holes drilled yet in the pics. It's all countersunk bolts now.

ridered3 · Nov 1, 2021

jeeptj99 · Nov 1, 2021

**** he makes some sexy toyota buggies

untchabl · Dec 1, 2021

Chris is killing it with the dash.

Blase · Dec 3, 2021

looking great!! can't wait to see it all finished up.

ridered3 · Dec 3, 2021

Man his tinwork (and work in general) is always so clean!

Jduck · Dec 4, 2021

Looks great! Chris does really nice work.

Dirt700 · Dec 6, 2021

That is looking good

jeeptj99 · Dec 7, 2021

I might have missed it how wide is the chassis going to be at the cab?

MarsFab · Dec 7, 2021

jeeptj99 said:
I might have missed it how wide is the chassis going to be at the cab?

At the base of the seats it's 49.5" and at the shoulders it's 53.5"

That's measured between the B-post

jeeptj99 · Dec 7, 2021

MarsFab said:
At the base of the seats it's 49.5" and at the shoulders it's 53.5"

That's measured between the B-post

Nice. My next one will be wider like that. I cant change the seats in mine at the moment.

MarsFab · Dec 7, 2021

jeeptj99 said:
Nice. My next one will be wider like that. I cant change the seats in mine at the moment.

I wish this could be narrower. The Toyota transfer case is tall and the output flanges is up high. I literally have the sides of the seats within a half inch of touching the case. The bottom of the case sits almost on the floor of the belly and the seats still sit over 10" off the floor. Unfortunately the only way I could have made it narrower would have been to mount the seats 6" higher throwing off the whole proportions of the chassis. In hindsight I probably would have leaned the b-pillars in at the top a few more degrees to give the illusion of the chassis being narrower but I didn't want the drivers head to be unprotected in a rollover.