Jeepasaurusrex
Well-Known Member
Does anyone know of a flat flange for the rear output of a Dana 300 that has a round 3R pattern (4.25"x4.25")? I have a CV drive line that I want to use in the rear that has that pattern.
-
Help Support Hardline Crawlers :
Dana 300 flat flange
- Thread starter Jeepasaurusrex
- Start date
CHOP SHOP
Well-Known Member
If thats the CV you want to use, WHY?
Thats a shitty saginaw CV with almost NO angle tollerance.
A spicer 1310 CV would be better for cheaper than a funky flange.
Or the link supplied lists a flange for a toyota CV pattern, also better than a SAGINAW.
Thats a shitty saginaw CV with almost NO angle tollerance.
A spicer 1310 CV would be better for cheaper than a funky flange.
Or the link supplied lists a flange for a toyota CV pattern, also better than a SAGINAW.
Jeepasaurusrex
Well-Known Member
Yea, I've decided to scrap that idea....
Going with a 1310 CV. The front output yoke on a 231 bolts up and is cheap.
Going with a 1310 CV. The front output yoke on a 231 bolts up and is cheap.
