Securing brake lines and hydro hoses to links?

kmcminn · Oct 5, 2018

sleepsontoilet said:
https://eversenperformanceproducts.com/collections/products/products/billet-bulkhead-mount

https://eversenperformanceproducts.com/collections/products/products/billet-bulkhead-mount-brake-line-axle-vent

Them look really nice. Reason I went with what I did is where I want hVe to bleed the brakes again after I install them.

MihlfeldL2005 · Oct 5, 2018

Anyone have a dwg file for something that could be 3d printed?

kmcminn · Oct 5, 2018

MihlfeldL2005 said:
Anyone have a dwg file for something that could be 3d printed?

Way to make the rest of us look like a bunch of cavemen. :****:

MihlfeldL2005 · Oct 6, 2018

Re: Re: Securing brake lines and hydro hoses to links?

kmcminn said:
Way to make the rest of us look like a bunch of cavemen. :****:

Seems like it'd be simple enough to make a clamp or something. 3D printing can be strong enough to hold a few hoses. I'm running hydro assist right now so no need for them but the next rig will have full hydro

kmcminn · Oct 7, 2018

Just put on the ajk clamps they worked out nice. Since they worked so good I ordered some for the rear brake lines. Unlike the other post I thought they were super easy to put on. Put on 3 in less than 10 minutes.

redneckengineered · Oct 12, 2018

kmcminn said:
Just put on the ajk clamps they worked out nice. Since they worked so good I ordered some for the rear brake lines. Unlike the other post I thought they were super easy to put on. Put on 3 in less than 10 minutes.

ASE certified as **** son!