-
Help Support Hardline Crawlers :
14 bolt rear steer
- Thread starter Metchosin joe
- Start date
ridered3
Not Rigless
What brand belt is that??? I've been using the green belts with good success so just curious where to get a blue belt since that has to be more better
Took me a while to find it, but there is one company making some brackets :
GM LS DUAL P-PUMP MOUNT BRACKET - APEBuilt
GM LS DUAL PSC HIGH FLOW P PUMP MOUNTING BRACKET (Truck Spacing) When running a dual steering Rockwell setup, or when you are needing hi-flow to keep up with oversized large hydraulic rams, APE Built's dual P-pump mount bracket will solve your problem. Drivers Side Mount for dual P Pumps CNC cut...
apebuilt.com
I think they're the only ones.
I have the goatbuilt brackets posted by @EddieHall but they are for CBR/TC type pumps.
They don't last long but they are cheap,and repairable with tape..What brand belt is that??? I've been using the green belts with good success so just curious where to get a blue belt since that has to be more better
Metchosin joe
Active Member
- Joined
- Sep 20, 2014
- Messages
- 44
Metchosin joe
Active Member
- Joined
- Sep 20, 2014
- Messages
- 44
Figure I'll bump this up
So my plan was to run equal length inners and that would put the pinion offset about 5".
Some how I missed the carrier offset in the 14 bolt. Unlike a 60 where the spline depth is the same on both sides of the carrier the 14 bolt has around a 2" difference.
so I'm bailing on the housing I've put about 5 pounds of wire into.
can any one give me some 14 bolt front measurements with stock 60 front shafts.
Like how far from center is your pinion and what stock length 60 shafts your running.
has any
So my plan was to run equal length inners and that would put the pinion offset about 5".
Some how I missed the carrier offset in the 14 bolt. Unlike a 60 where the spline depth is the same on both sides of the carrier the 14 bolt has around a 2" difference.
so I'm bailing on the housing I've put about 5 pounds of wire into.
can any one give me some 14 bolt front measurements with stock 60 front shafts.
Like how far from center is your pinion and what stock length 60 shafts your running.
has any
chaplinfj60
Active Member
- Joined
- Jul 27, 2022
- Messages
- 32
bump
What do you need?
ridered3
Not Rigless
Wanting cheater steer after one week at AOP?
chaplinfj60
Active Member
- Joined
- Jul 27, 2022
- Messages
- 32
maybe lol maybe i just like the idea of being like the cool kids... lolWanting cheater steer after one week at AOP?
so some random thoughts on what i like about my set up. i like the 40s, big enough to do most things but small enough to keep the rotating mass down. but also too small and it requires me to skinny pedal alot more than needed. but if i could steer my rear tire to exact ledge or rock. then that would be good deal. alos because i am on the average height. 5"7" i dont want to get much taller. another bonus for 40s again had a long ride home to discuss many ideas.... and rear steer was discussed.... lol
ridered3
Not Rigless
Speaking on behalf of @Bebop do it!
For some of our trips, I'm the little tire guy on 39" Reds, so I totally follow your thinking. Having ridden with @rafter b2000 a handful of times, cheater steer sure is fun.
