-
Help Support Hardline Crawlers :
Little Gibby's 45 MB
- Thread starter Gibby1
- Start date
crash2
-Oh no I picked a side-
I wasn't sure when you needed it. I will order it today.
crash2
-Oh no I picked a side-
crash2
-Oh no I picked a side-
Wrong address,lol..
Might be easier/cheaper to just box them up and ship them over...
Might be easier/cheaper to just box them up and ship them over...
WHITE TRASH1
fruit stripe
Is that really a Rockwell 221 behind a 465? If so damned good idea to keep the rear driveline angle in check!
Good eyes.
Why any different with this unit? This was quite short and the rear output is low on the Rockwell.
It actually seems to line up very well.
crash2
-Oh no I picked a side-
In check is an understatement. With the HP its beautiful...
It's just a little baby, around 200Hp.
crash2
-Oh no I picked a side-
TreeClimber
Well-Known Member
Wow.HP=High Pinion
Should have put a 4.3 in it
8 years on a build, and it didn't get parted out.
crash2
-Oh no I picked a side-
Sorry about the parts. I JUST found out that Lee heard traffic was bad on Highway 2, so he decided NOT to drop the parts off and just come home...
UGHHH!
Just ordered the seats.
http://prpseats.com/product/suspension-bench-seat/
50" bench with 2 headrests, slots for the 5 point harness and the mud bottom. You should see them at your door Mike on April 13th.
The other parts, I have NO idea where they went. Lee decided to come home on Thursday instead of risking the traffic to Monroe on Thursday afternoon. Today, I cannot find him or my parts, or my business truck that he is using, even though he's not at work today ARGHHHHH.
I was trying to leave 30 minutes ago to beat traffic but the parts are not where they are supposed to be. I am wondering if he came and picked them up since I already drove to his house in Maple Valley to get them once today. Finally got him on the phone and he says they are at my house... Seriously???
http://prpseats.com/product/suspension-bench-seat/
50" bench with 2 headrests, slots for the 5 point harness and the mud bottom. You should see them at your door Mike on April 13th.
The other parts, I have NO idea where they went. Lee decided to come home on Thursday instead of risking the traffic to Monroe on Thursday afternoon. Today, I cannot find him or my parts, or my business truck that he is using, even though he's not at work today ARGHHHHH.
I was trying to leave 30 minutes ago to beat traffic but the parts are not where they are supposed to be. I am wondering if he came and picked them up since I already drove to his house in Maple Valley to get them once today. Finally got him on the phone and he says they are at my house... Seriously???
WHITE TRASH1
fruit stripe
That's awesome. Nobody uses the case because they can be hard to find parts for. They are rather tough though so I doubt t you'll have any issues with it. I'd never actually thought about using one of them in a flatty, it's pure genius. :redneck:
crash2
-Oh no I picked a side-
Is this the one you were talking about dale?
Genious, aka a stroke of BS luck!
I believe so. I ordered and sent you one a while ago. IIRC, we have an edlebrock manifold on there and that should have fit.
I know we are both getting older and this has been going on for a LONG time... but I recall you test fitting it and saying that it would work.
Looking at the pic of the installed motor, there's already a thermostat housing on there :confused
Last edited:
