Little Gibby's 45 MB

crash2 · Aug 30, 2015

And the wiring is pre-ran to under the dash.

This is where james will have to take over since I have no clue whats instore in the dash but everything is marked with plenty of wire...

With the length I left for the Ecm there should be some good options for its mounting. There is a sweet spot for it on top of the heater box but I don't suggest it going there due to the heat factor.. It needs a spot that will get some air and water resistant....

crash2 · Aug 30, 2015

Made a change this morning and swapped the 3/8 stuff for some 1/2. The 3/8 was a little restrictive.

crash2 · Aug 30, 2015

Time for more wire :redneck:

crash2 · Aug 30, 2015

Ran the front/rear wiring thru the same pass thru harness..

crash2 · Aug 30, 2015

The front/rear harness is done. I pre-wired Park lamps/brake lamps/LH&RH turn lamps. I also pre-wired for a fuel sender in case dale wants to add one to the tank down the road and also a turn on wire for the air pump.

Gibby1 · Aug 30, 2015

Fuel gauge sender unit is a must. I wasn't sure how to add one in.

crash2 · Aug 31, 2015

Gibby said:
Fuel gauge sender unit is a must. I wasn't sure how to add one in.

The signal wire is roughted in for when the time comes

crash2 · Sep 12, 2015

Got the main junction pass thru installed and all the main power feeds from there forward done (alt, starter and winch). That finishes the wiring I will be doing.

whats the status of the shocks dale?

I can't remember if stated some time ago but its also missing the dipstick tube.

Gibby1 · Sep 12, 2015

Shocks have arrived. I need to get them and a few other parts, up to you.

crash2 · Sep 12, 2015

Gibby said:
Shocks have arrived. I need to get them and a few other parts, up to you.

I have 2 weeks and it has to be done as I have to get my gold bar house ready to go on the market and another big project to start.

Gibby1 · Sep 12, 2015

crash said:
I have 2 weeks and it has to be done as I have to get my gold bar house ready to go on the market and another big project to start.

OK, I guess I had better find a way to get those up to you ASAP!

zukkev · Sep 12, 2015

crash said:
I have 2 weeks and it has to be done as I have to get my gold bar house ready to go on the market and another big project to start.

Wait, soooooo you're saying this thread will officially end in two weeks.....after HOW many years??? :fawkdancesmiley: :haha: :hello:

Gibby1 · Sep 12, 2015

zukkev said:
Wait, soooooo you're saying this thread will officially end in two weeks.....after HOW many years??? :fawkdancesmiley: :haha: :hello:

James is going to have to keep it going for a bit with his finishing touches.

TreeClimber · Sep 12, 2015

zukkev said:
Wait, soooooo you're saying this thread will officially end in two weeks.....after HOW many years??? :fawkdancesmiley: :haha: :hello:

Jan 15, 2007.... so, about 8 and 1/2 years.

Jacob · Sep 12, 2015

I thought eviction notices had to be 30 days and not 14?

crash2 · Sep 12, 2015

Jacob said:
I thought eviction notices had to be 30 days and not 14?

I thought about it 31 days ago--so that counts :fawkdancesmiley:

zukkev · Sep 12, 2015

:haha:

pokey · Sep 12, 2015

More like an abandoned vehicle issue.

Gibby1 · Sep 16, 2015

SM465 shifter parts are on the way to you Mike.

The water neck and distributor hold down are ordered but they had to ship to me, then I will forward them to you.

Shocks and hoses should be on your doorstep on Thursday.